Trollskull Manor - Playable size (28mm)

TLDR: This is a playable sized Trollskull manor from the DnD campaign Waterdeep: Dragon Heist. Print one of everything, add some glue and magnets and you're good to go! [**Final result**](https://www.youtube.com/watch?v=qSk7tmHO3ps) **UPDATE**: 1) Initial update contained the wrong TSM_0_a file, if you downloaded the old one, a new one has been uploaded. The new version however had an alignment issue with the magnet holes, you can either do what I did - use a drill to make new holes - or download the v2 version with the correct alignment. 2) Somehow the TSM_3_b file was not correct - A magnet hole had a protrusion. I couldn't locate the correct file. I couldn't adequately fix the newly generated version with netfabb or meshmixer and therefore used makeprintable to produce a fixed version "TSM_3_b_2.obj" - It looks ok but is untested (the "raw" unfixed version had geometry issues and was previously uploaded but has since been removed for simplicity reasons). 3) The TSM_4_b_2 file had a chimney that was 4 mm too short to connect with the magnet from the floor above. If you've printed the TSM_4_b_2.stl that was initially uploaded you can download the TSM_4_b_2_Chimney-fix and glue it on top of the chimney, note that there is a hole straight through this shim as a floor could've caused the magnet to protrude. If you haven't printed it yet, just use the TSM_4_b_2_fixed.stl file!