The Expanse MCRN Corvette - Rocinante

UPDATE 30th August 2021: Quick update - I haven't forgotten this thing, and I do have some plans for the future - just don't have the time for it right now. That being said, I would like to divert your attention to the two remixes that are currently up - One updates the back section with cargo doors, the other includes the Season 4 changes - landing gear and rail gun! Both are excellent additions to the design :) UPDATE 23th June 2020: User [Freich](https://www.thingiverse.com/freich/about) spotted a mistake, I accidentally uploaded a wrong version of the PDC stand. Should be fixed now. I have also uploaded a new version of the stand with a deeper cutout at the back, called Roci-Stand-Addon-PDCs.stl. Depending on your method of attachment for the standalone PDCs, this one might be a better fit. I recomment testing the fit by printing only the top part of the stand (e.g. in Cura by pushing the stand 41 mm into the ground). UPDATE 7th May 2020: Added (a very WIP version of) standalone PDCs. You can now print the sleek version of the Roci and add PDCs later, should you wish. You can even rotate them around. These NEED to be printed with supports set to "everywhere" and the supports can be a pain to get off, especially under the gun body (behind the barrel). I used snips to clean up everything I could and the butt end of a nozzle cleaning needle to push the most resilient pieces of support out. Using selective manual supports or support blockers would probably be ideal. You can use glue to attach the standalone PDCs to the Roci. Alternatively, slim double-sided tape could work for non-permanent attachment. I have not yet tried this, so no idea if the tolerances are right and if it will look good. DISCLAIMER: The standalone PDCs have some rough edges (pun intended) around their bases that I need to clean up. I don't have a lot of time currently, so this WIP rough version was released based on user demand. Please keep that in mind. ORIGINAL T