Akantor - Monster Hunter

Beware of this fearsome beast, behold the Akantor So this model has been a longtime coming, So i sourced the model from https://www.deviantart.com/rough-chrysalis/art/Akantor-719624774 but it wasn't intended for 3d printing. So after creating a couple of poses, making model water tight, then I increased the poly count to make him less blocky, I also sliced him up to make it easier print and to fit on a 220x220mm printbed. The parts are scaled for use in DnD. I include some holes for alignment pins to make assembly eaiser. The holes are 5mm in diameter, so you could use a 1/4inch drill bit to remove any supports inside the holes. The alignment pin model is a exact fit, so you may have to scale the pin down to fit. How much depends on the accuracy of your printer. Also the head and tail pieces have been combined to give you additional printing options. I've include whole models as well, both high poly count and low in both poses. I hope ya'll like it