TF2 stock syringe gun

wanted to make myself a full medic loadout for a cosplay, and although it might be the worst, I think the syringe gun looks the coolest out of his primaries. to make this you will also need a clear 2 liter soda bottle for the clear tube. everything else is a 3d print. also note that it is quite large, however it had to be scaled to fit the bottle, and the gun in game is quite large too. the model was ripped from the game, cleaned up, and cut into printer friendly pieces, so It's about as accurate as you can get. print one of all pieces except clear tube, full syringe, and all syringe pieces. clear tube and full syringe are just for reference, and you need to print thirteen of syringe pieces 1-6 for thirteen syringes assembly instructions: I have left some pictures to hopefully help show what to do, as there are quite a lot of pieces. 1: make your syringes. they need to be made in halves first, so connect all the 1, 2, and 3 pieces, and the 4, 5, and 6 pieces separately 2: assemble the syringe chamber. attach syringe chambers front and back to the syringe holder 3: now lets get the bottle ready. Make a line around the circumference of the bottle where you want the bottom of the tube to be 4: make a 13 cm line down the length of the bottle 5: at the top of this line make another line around the circumference for the top of the tube. 6: cut the top and bottom off the bottle at the lines, then cut the bottle along the vertical line. 7: fit one end of your tube into its slot on the front red cap. DO NOT GLUE IT IN 8: fit the rest of the tube into the slot. you'll notice that the tube is too long for its slot, so make a mark where the slot ends. 9: make a line from this mark, so you have a thin strip of material to cut away so it will fin in the slot. Now cut of the small bit of excess material. 10: the tube should now fit into the red ring. fit in in on both ends to create a full tube. STILL NO GLUING 11: fit the handle into the main body (now you can glue