Stomp Wing X

https://youtube.com/shorts/vDayGSyOSQE?feature=share Based on the idea of my vather after demonstrating him LoboCNC`s Stomp Rocket, he was saying this might work with a wing design too so I started my own project. During the creation I then figured that Lobo already made a Wing Variant of it, but I still wanted to create my own ^^... My goal was to build a wing that actually flies well (as much as it is possible with heavy PLA) and looks somewhat special. I wanted to give the Launcher Tube a more aggressive angle for a little bit better flight performance so I made it a separate part as well as creating a slightly bigger Base and Plunger for a little bit more air pressure. NOTE: Not Compatible with LoboCNC`s design! Stomp Wing X - IT FLIES! This is a 0.4mm single wall print. I had some issues with the Cura v4.13.1 not beeing able to print it without layer line fragmentation when slicing. My solution was to print it with ~0.044 horizontal expansion. The Nose needs a minimum of 50-65% infill to make it heavy enough to fly. Brim is recommended for this single wall print. Stomp Wing X Tube The tube needs Support and brim is recommended. The tube is meant to be glued with SEKUNDENKLEBER... I mean superglue to the base. Make sure you used enough glue so the air can't break out. Stomp Wing X Base & Plunger For a tighter fit (more air preasure) you can print the base with 0.044 Horizontal Expansion too. Both can be printed without supports and infill as you wish (I printed with 18% infill). Make sure you always have some superglue available for little layer repairs :D! If you stomp strong enough (DON'T BREAK IT!) you can achieve 1-2m! Thrown by hand you can easily fly more then 2 meters :)! Have Fun!