Industrial pipe components for Warhammer40k

Component list: -90° elbow LEFT hand turn -90° elbow RIGHT hand turn -90° elbow DOWN/UP turn -Little top T-section cap I have made 3 different elbows, and a top cap component that can be added to a length of plastic piping. The specific pipe I used is shown in the link below, but you can try other pipes as well as long as the outer diameter is 42.27mm or 1-11/16th". I have included a link below that shows the type of pipe you should use for the straight section: http://tinyurl.com/htmvo4s I used a "Form2" printer, @ 0.025mm print resolution to make the parts shown in the image above, so you may need to do a bit of sanding and finishing if you plan on printing with any printer that works at a lower resolution.