The Thinker Toothpaste Cap

Edit: found the one I had seen before, check it out: https://www.thingiverse.com/thing:2022505 Thingiverse search never brought this up when I was searching before but I guess it's been fixed. Not an original idea but I couldn't find an available model so I had to get a little down and dirty to figure it out myself. You might have to give it a thorough wash once in a while. It gets quite ... plugged up ... as toothpaste sits in the pipe and dries up a little. Smears on the rear, too. Enjoy a bit of humour in your morning/evening routines! Make sure you clean out the pipe and threaded portion of the print. Don't want plastic in your toothpaste. I read that Crest and Colgate have different size threads but I've used it on both brands and it works just fine (the measurements were based on a Colgate tube). Not sure about other brands, unfortunately. There are 2 files, one with a 5/8" inner diameter thread and one with a 1/2" inner diameter thread. From what I've read the 5/8" should fit a Colgate tube and the 1/2" should fit a Crest tube. For anything else, and future changes, please try scaling your print by a few %. Check out the discussion on this thing for scaling https://www.thingiverse.com/thing:158910 Not that it matters to you but I used some stupid combination of Blender and Onshape to modify the original Thinker model (linked below) and to make and add the pipe and the threaded portion. I'm proud of it :D This is a remix from https://www.thingiverse.com/thing:398515 and the original is here https://www.thingiverse.com/thing:2022505. I tried adding them to the "remix" section of the thing but Thingiverse "can't find" them.