The Cryptid Conversion: A Pump Action Clip Fed Nerf Sledgefire Conversion

What would be the Achilles Heel of a Sledgefire? The long reload cycle perhaps. And to remedy this, in designing this monstrosity I have sacrificed everything: simplicity, optimal print orientations, even common sense. Still in terms of nerf “shotguns” this cross between a magstrike and a folding chair has much to offer. This front-end replacement completely reconfigures the sledgefire into a pump action shotgun, capable of using clips of varying capacity and ammo type: classic triple shot, mega, and rival. Despite it’s freakish looks the folding lever pump mechanism can - with reinforced internals - still prime heavy spring loads; with the max load I’ve tested (read: max I was able to fit inside the sledgefire) being 17 coils of pro-26. This mod isn’t for everyone, but I’m sure at least some of you will find a use for it. Firing Demonstration: https://www.youtube.com/watch?v=-yjHaoFNQUo&ab_channel=GunnerLeo All Clip Variants Avalable: https://www.thingiverse.com/thing:5758010 Hardware Parts List: - ONE (1): 16cm of 50mm coloured PCV - ONE (1): 20.5cm of 20mm coloured PVC - ONE (1): ~30cm of 3mm bungee cord - ONE (1): 3mm thick one side adhesive foam pad cut into a 42mm diameter circle with a 20mm hole cut into it. - ONE (1): 2mm x 20mm Metal Pin (I used a cut down nail if it’s in the ballpark it should work) - ONE (1): Spring small and short enough to fit into the 6.8mm diameter hole of the clip retainer notch. I used a piece of 7/32 Inch diameter spring cut to about 1.5 CM - TWO (2): 10-32x1 Inch Flat Socket Head Machine Screws - FOUR (4): 8-32x3/4 Inch Flat Socket Head Machine Screws - ONE (1): M6 x 20mm Grub Screw - TEN (10): M2.6 x 16mm Pan Head Screws - TWO (2): M2.6 x 10mm Pan Head Screws (Can be self tapping or not) - SIX (6): M2.6 x 8mm Pan Head Screws (Can be self tapping or not) - PLA safe thread locker or super glue for the M6 grub screw [OPTIONAL for reinforcing the sledgefire with a spring upgrade] - One (1) X